X-Git-Url: http://git.ozo.com/?a=blobdiff_plain;f=docs%2Fnetwork.tex;h=783db464dd309de029445cfdfdf47ad9aee1b444;hb=6e2ed99ca37ae4140552fc24ce7b8bac9e156133;hp=df67eed714d2f874bec8c799f64ffc8cfa29d2a2;hpb=3ac745fdfb96b1efef0f0fd41ebb3ba9a211c2c8;p=openwrt-10.03%2F.git diff --git a/docs/network.tex b/docs/network.tex index df67eed71..783db464d 100644 --- a/docs/network.tex +++ b/docs/network.tex @@ -114,3 +114,50 @@ config switch "eth0" option vlan1 "0 5" option vlan2 "4 5" \end{Verbatim} + +\subsubsection{Setting up IPv6 connectivity} + +OpenWrt supports IPv6 connectivity using PPP, Tunnel brokers or static +assignment. + +If you use PPP, IPv6 will be setup using IP6CP and there is nothing to +configure. + +To setup an IPv6 tunnel to a tunnel broker, you have to edit the +\texttt{/etc/config/6tunnel} file and change the settings accordingly : + +\begin{Verbatim} +config 6tunnel + option tnlifname 'sixbone' + option remoteip4 '1.0.0.1' + option localip4 '1.0.0.2' + option localip6 '2001::DEAD::BEEF::1' + option prefix '/64' +\end{Verbatim} + +\begin{itemize} + \item{\texttt{'tnlifname'}:} + Set the interface name of the IPv6 in IPv4 tunnel + \item{\texttt{'remoteip4'}:} + IP address of the remote end to establish the 6in4 tunnel. + This address is given by the tunnel broker + \item{\texttt{'localip4'}:} + IP address of your router to establish the 6in4 tunnel. + It will usually match your WAN IP address. + \item{\texttt{'localip6'}:} + IPv6 address to setup on your tunnel side + This address is given by the tunnel broker + \item{\texttt{'prefix'}:} + IPv6 prefix to setup on the LAN. +\end{itemize} + +IPv6 static addressing is also supported using a similar setup as +IPv4 but with the \texttt{ip6} prefixing (when applicable). + +\begin{Verbatim} +config interface "lan" + option ifname "eth0" + option proto "static" + option ip6addr "fe80::200:ff:fe00:0/64" + option ip6gw "2001::DEAF:BEE:1" +\end{Verbatim}