switch ixp4xx and ubicom32 to 2.6.30, get rid of 2.6.28 files

[openwrt-10.03/.git] / target / linux / au1000 / patches-2.6.28 / 004-state_led_phy_fix.patch

diff --git a/target/linux/au1000/patches-2.6.28/004-state_led_phy_fix.patch b/target/linux/au1000/patches-2.6.28/004-state_led_phy_fix.patch
deleted file mode 100644 (file)
index e681970..0000000
--- a/target/linux/au1000/patches-2.6.28/004-state_led_phy_fix.patch
+++ /dev/null
@@ -1,31 +0,0 @@
---- a/drivers/net/au1000_eth.c
-+++ b/drivers/net/au1000_eth.c
-@@ -184,6 +184,15 @@ struct au1000_private *au_macs[NUM_ETH_I
- #  undef AU1XXX_PHY1_IRQ
- #endif
- 
-+#if defined(CONFIG_MIPS_MTX1)
-+/*
-+ * 4G MeshCube (MTX-1) board
-+ * PHY is at address 31 on MAC0
-+ * autodetect fails if not searched for highest address !
-+ */
-+# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
-+#endif
-+
- #if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
- # error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
- #endif
-@@ -380,6 +389,12 @@ static int mii_probe (struct net_device 
-       aup->old_duplex = -1;
-       aup->phy_dev = phydev;
- 
-+#ifdef CONFIG_MIPS_MTX1
-+      /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
-+      printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
-+      phy_write(phydev, 0x11, 0xff80);
-+#endif
-+
-       printk(KERN_INFO "%s: attached PHY driver [%s] "
-              "(mii_bus:phy_addr=%s, irq=%d)\n",
-              dev->name, phydev->drv->name, phydev->dev.bus_id, phydev->irq);